新闻讯息

首页 > 新闻讯息
盖板模具的施工步骤介绍
发布人:管理员   发布时间:2020-12-22

盖板模具采用工程塑料聚丙烯为主要生产材料,生产出来的产品脱模快,那么此模具在施工中有哪些步骤要呢!
Cover mold using engineering plastic polypropylene as the main production material, produced products demoulding fast, so this mold in the construction of which steps to!

1.施工之前就是需要制定一套完整的方案,使用环境的路线也要规划好,提前检测好施工场地。
1. Before construction, it is necessary to formulate a complete scheme, plan the route of using environment, and inspect the construction site in advance.

2.施工的场地检测好之后做好施工隔离准备,然后将使用的机械设备以及各种零件也要准备好,施工现场也要准备好水电保证施工的过程是完整的。
2. After the construction site is inspected, the construction isolation preparation shall be made, and then the mechanical equipment and various parts used shall be prepared, and the construction site shall also be prepared with water and electricity to ensure that the construction process is complete.

      

3.盖板模具的施工路线要整齐,我们在铺设的时候一定要非常紧密可以使用混凝土填缝,这样在施工效果上会更好,另外我们施工的环境也要做好安全防护措施,减少施工中出现的意外情况。
3. The construction route of the cover mold should be neat. We must be very close when laying. We can use concrete to fill the joint, so that the construction effect will be better. In addition, we should take safety protection measures to reduce the accidents in the construction.

4.施工之后我们要清理施工现场,拆除临时搭建的设施,收拾好使用得到的机器,避免遗漏,对于施工之后的盖板我们可以做一个定期的检修保证使用效果。
4. After the construction, we should clean up the construction site, dismantle the temporary facilities, clean up the used machines, and avoid omission. For the cover plate after construction, we can do a regular maintenance to ensure the use effect.

 

上一篇:没有了