新闻讯息

首页 > 新闻讯息
如何延缓盖板模具老化
发布人:管理员   发布时间:2020-10-13

我们美丽的盖板模具,该如何延缓模具老化,下面给大家介绍几个延缓模具老化的方法。Our beautiful flat mold, how to delay the aging of the mold, the following to introduce a few ways to delay mold aging.

1、盖板模具包装严密、整洁。2、应严格入库验收,禁止质次或已老化变质的份子化合物塑料制品入库。
1. The cover mould is packed tightly and neatly. 2. Strict warehousing acceptance shall be carried out, and inferior or aged and deteriorated molecular compound plastic products shall not be put into storage.

3、应切实的保持存放模具的库房清洁、墙壁、门窗应刷上白色,制止阳光直射,同时不能同仓存储油类、腐化性及含水量较大的商品。
3. It is necessary to keep the warehouse where the mould is stored clean, the walls, doors and windows should be painted white to prevent direct sunlight. At the same time, it is not allowed to store oil, corrosive and water content goods in the same warehouse.

        

4、底层仓库一定要隔离地潮,露天货垛要做好相应的防晒、防雨、防风、防止露垛。5、增强模具的仓库温湿度管理,份子化合物塑料制品一般要求相宜温度在30℃以下,相对湿度60%~80%
4. The bottom warehouse must be isolated from the ground tide, and the outdoor Cargo Stack should be well protected against sun, rain, wind and exposure. 5. To enhance the warehouse temperature and humidity management of mold, molecular compound plastic products generally require appropriate temperature below 30 ℃ and relative humidity of 60% ~ 80%

以上是对盖板模具延缓老化的介绍。The above is the introduction of delay aging of the cover die.

 

上一篇:没有了